CISCO MDS 9124 CONFIGURATION GUIDE PDF

Example Cisco MDS Switch Default Port License Configuration. switch# show port-license Available port activation licenses are 0. Cisco MDS Family Quick Configuration Guide. OL Using the Switch Setup Utility Verifying the Module Status CHAPTER. 3. Configuring. Note If a Cisco MDS or switch is used as a core switch, only a nontrunking F PortChannel is supported. Trunking is not supported on.

Author: Mikalmaran Dajin
Country: Solomon Islands
Language: English (Spanish)
Genre: Health and Food
Published (Last): 20 July 2011
Pages: 46
PDF File Size: 11.66 Mb
ePub File Size: 20.49 Mb
ISBN: 879-7-48495-985-1
Downloads: 66695
Price: Free* [*Free Regsitration Required]
Uploader: Kajishicage

When you join two switches belonging to two different stable fabrics that have overlapping domains, the following cases apply: I am not sure. This however would be very nice to have in the documentation for IPS network simulator, an example showing complete configuration of Gigabit Ethernet interfaces and FCIP tunnels to go along with the Network Simulator.

Proudly powered by WordPress. Leave a Reply Cancel reply You must be logged in to post a comment.

Unofficial Cisco MDS Release 3.x CLI Config Guide Errata – Maximum Entropy

Page shows with 8 base ports 8 licensed for growth. Page Document states: On the same page I find this block of text very vague and confusing: Page Information is repeated twice on the same page: From time to time I will blog about other guire of interest.

  ESTADO HIPEROSMOLAR CETOSICO PDF

Testing indicates that this is in fact enabled by default. It is worded as if it is a requirement but it is in fact not.

These pages talk about an active mode of fcanalyzer. I am not sure if this is valid. The way its written sounds like if you have a large scale deployment where you need explicit LUN access control you can use proxy-initiator, but its really the opposite. Although it can be configured it has no effect. If a domain is currently isolated due to domain overlap, and you later enable the autoreconfigure option on both switches, the fabric continues to be isolated.

This is not correct as this does not work. FCIP uses different ports. I think what is meant here is: Certainly there is either a mistake in the wording or the example.

This is not correct. This should be made more clear. The default authentication port is The opinions expressed in this blog are entirely my own and should not be taken as the opinion of my employer. You can nondisruptively reconfigure the fcdomain by changing the configured domains on the overlapping links and getting rid of the domain overlap.

  GOLINOWSKA POLITYKA SPOECZNA PDF

Should be 8 base ports, which can goto 8 or 16 additional ports. Reconfiguration as in changing of domains is always disruptive. Then states two bullets later: This blog is mostly about my pursuits in Data Science. In this case, using the proxy initiator mode simplifies the configuration.

You do not need to restart the fcdomain.

A disruptive reconfiguration may affect data traffic. Caution The span drop-threshold can be changed only if no span sessions are currently active on the switch. Page Figure shows incorrect ip default-gateway Page States in one bullet: The autoreconfigure option takes immediate effect at runtime.

Unofficial Cisco MDS Release 3.x CLI Config Guide Errata

Cisco Documentation team has internally re-written this as: This situation can require several configuration tasks for each iSCSI host. I am not sure that the statement in bold is correct. This page incorrect states that fcns reject-duplicate-pwwn is disabled by default.